ferelinux.blogg.se - Issues using drive snapshot with windows 10 raid volume

A Brief Introduction: RAID 6 vs RAID 10.If you don't know the difference between RAID 6 and RAID 10, this post may help you, in which MiniTool elaborates on RAID 6 vs RAID 10, and gives you advice on how to protect data and uptime. This should extend the file system on the drive, and the disk should be accessible.Choose RAID 6 or RAID 10? This is a question. To do this, run the following command: FSExtend Then, run FSExtend on the drive to extend the file system. Run the following command on the disk to fix any errors on the disk: chkdsk /f Īfter chkdsk is completed successfully, restart the server. To do this, run the following command: chkdsk d: /l: 65536 /f If you can access the disk, you should free up some free space and then return the NTFS transaction log to the default value of about 65 MB.

To shrink the NTFS transaction log to 4 MB, run the following command: chkdsk d: /l:4096 /fĭetermine whether you can access the disk.

Then, the disk will have enough space to mount the volume. If there is too little disk space to mount the volume, shrink the NTFS transaction log to 4 MB. To resolve this issue, use one of the following methods.

There is not enough disk space for the file system extend.

The file system structure on the disk is corrupted.

The issue occurs because of one of the following reasons: Please run the chkdsk utility on the volume : Cause The file system structure on the disk is corrupt and unusable. However, when you run chkdsk, the file system is shown as NTFS.Īdditionally, you see the following error message in the System log: When you extend a volume by using FSExtend, the volume may show as raw in disk management. This article provides solutions to an issue where a volume shows as raw in disk management but chkdsk shows the file system as NTFS after you extend the partition.Īpplies to: Windows Server 2012 R2 Original KB number: 2261358 Symptoms